ENGINE: cylinder head and related gasket, timing gears, engine block, camshaft, main bearings (crankshaft main bearings), piston rod bearings (crankshaft piston rod bearings), shafts and rocker arms, crankshaft, piston rods, oil pump, hydraulic tappets, rocker arm unit, intake valves (not carbonised, burnt, corroded), exhaust valves (not carbonised, burnt, corroded), valve guide, head tappet cover gasket, pistons, timing chain (including tensioners), piston rings
GEARBOX: main shaft, secondary shaft, EAS gear sensor kit, complete freewheel start, gears, gearbox bearing, oil gaskets, radial shaft seals, control unit
FUEL: electric fuel pump, throttle and injectors, float
ELECTRIC CIRCUIT: alternator, engine starter, ride-by-wire gas control, lambda sensor, navigation device (only if included as standard), heated hand grips
ELECTRONIC COMPONENTS: injector unit, instrument-dashboard panel
COOLING SYSTEM: radiator, water pump, radiator electric fan
BRAKING SYSTEM: master cylinder, ABS or hydraulic aggregate pump (hydraulic part only), ABS electronic unit
CLUTCH: clutch master cylinder, secondary cylinder; LABOUR: detach and reattach according to time required and the manufacturer’s instructions applied exclusively to the breakage of pieces covered by the Warranty, excluding diagnosis and finding the fault
1. Check that all work has been carried out according to the scheduled maintenance plan
2. Visual check of suspension seal elements
3. Check presence and possible removal of non-approved installed components, replacing them with components supplied from the previous owner or purchased from MV Agusta
4. Check that the motorcycle complies with applicable legislation
5. Check for any alterations to the motorcycle
6. Check non-original MV Agusta components installed
7. Visual check of fuel pipes and seals
8. Visual check of points of contact, movement freedom and correct position of flexible cables and exposed electric wiring
9. Check lever play and controls
10. Lubrication of handlebar levers and foot controls
11. Check final drive wear
12. Check tension and lubrication of final drive chain
13. Check tightening of the rear wheel hub unit
14. Check rear wheel hub unit wear
15. Check rear wheel bearings and steering bearings
16. Check tightening of all safety components (rear and front brake calliper fastener screws, brake discs, brake master cylinders, etc.)
17. Reading of control unit diagnostics and check that software version is up to date (if available)
18. Check presence of any recall campaigns and technical updates
19. Check tyre pressure and wear
20. Check battery and charger circuit level
21. Check engine oil level
22. Check function of electronic safety devices
23. Check for engine leaks
24. Check lighting devices, indicators, horn and controls
25. Check coolant level
26. Check oil level in brake and clutch systems and their correct function
27. Check correct function of brake and clutch systems
28. Check for cooling system leaks
29. Check wear of brake pads and discs
30. Check upcoming maintenance (dashboard service function)
31. The motorcycle must not have been involved in an accident in agreement with previous owner
32. Complete check of the kit provided, instruments, second key, card code, user and maintenance manual, etc.
33. Check correct function of keys and insertion of the steering lock
34. Standard dashboard setting (adjust time, enable EAS, etc. or factory reset of settings where available)
35. Fill up with fuel until reserve light goes out
36. Test motorcycle in stationary position and on the road with check of the correct function of all devices (ABS, EAS, etc.), electric fans, minimum speed, gearbox and clutch
37. Complete cleaning of the motorcycle